I did find a polish publication that mentioned the older dos version setup was 1200, 7 bit, 2 stop bits which my manual has absolutely nothing on computer interfacing for either the 9140 or 9150. I've tried all but the ME series meters and no joy. The software setup asks for the baud rate stop bits, etc and also asks you to choose from several Metex models, none of which are the 3640d. Still no communiction with the supplied DB-25-db-25 cable that came in the box with a 9 pin adapter.
I have the v1.09 scopeview software up and running under an old laptop running win 98.
I've seen data sheets with the 9150/9160 as co-products under the Unisource label dating to 2006 or 2007, not sure on that when I was trying to find a veneer drive replacement for one of the earlier MS-9140 units. This unit must have been manufactured after the 42 week of 2003 by latest date codes on some of the chips, well into XP dating.
Modern methods for robust regression pdf viewer. I did find an independent freeware Mscope that's supposed to work with some of the Metex meters and a V1.08 searching, but I'd like to find the last version. The Tenma72-5085 should be the full,standard version of the MS-9150 with the 4000 count DMM, 1.2 gig timer/counter with no differences unlike some of the other OEM versions that had reduced features and specs that looked just like it. Does anyone know of what the latest software is and where to find it? I've seen Unisource handhelds shown packed with a CD during past years and wonder if that is a more updated product that will work with XP or later. The Metex.KR address doesn't seem to get any response if you write them or look at their website for any downloads or support. If they still make it with the DB25 RS-232, something must work with it. It apparently will not run under XP even these units I think are still available as the 9150/60 and the newer 9170, I can't find a hint of support for the software or if any of the latter Metex/Unisource or any of the jobbers such as MCM,Tenma,Elenco,Voltcraft,Conrad or anyone else that sold these has updated software that will work with this unit. I've got a MCM version of the Metex MS-9150 working again and the software diskette that came with cable kit was Scopeview V1.09 when it was purchased as an accessory kit from MCM. Metex Ms 9150 Service Manual Pdf Metex Ms 9150
0 kommentar(er)
